Related Manuals for Casablanca Hunter 595754CF
Summary of Contents for Casablanca Hunter 595754CF
-
Page 1: Table Of Contents
1.888.227.2178 What to Expect with Ceiling Plate Hanging the Fan Your Installation Preparation 30 inches 7 feet Ladder Canopy Wiring Blade Switch Housing Maintenance Light Kit Wall Control & Cleaning Troubleshooting M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company... -
Page 2: What To Expect With Your Installation
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company... -
Page 3: Preparation
Preparation www.CasablancaFanCo.com 1.888.227.2178 Wire Strippers Screwdrivers Ladder Power Drill 9/64” Drill Bit (optional) (optional) If mounting to a support structure, you will also need these tools. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company... - Page 4 To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location. Refer to warning w.1 on pg. 2 M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
-
Page 5: Ceiling Plate
Place the slots over the ceiling plate the canopy slots sit on the ceiling plate hooks. least 8” extending from the top of hooks to hang the fan. the canopy. 8” 3/8” M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company... - Page 6 Spread the wires apart, with the grounded wires on one side of Refer to CAUTION c.1 on pg. 2 the outlet box and the ungrounded wires on the other side of the outlet box. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 7 Spread the wires apart, with the grounded wires on one side of Refer to CAUTION c.1 on pg. 2 the outlet box and the ungrounded wires on the other side of the outlet box. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 8 Note: The slots in the canopy must hardware bag. remain engaged while swinging the WARNING canopy for alignment. FAN FALL HAZARD To prevent SERIOUS INJURY or DEATH, make sure that the canopy is properly secured. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 9 Put each blade washer, found in hardware bag, onto a blade screw, found in the hardware bag. Then secure each blade to a blade iron using the blade screws and washers. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 10 It does not matter which counterclockwise. two screw holes you choose. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 11 Switch housing. It does not matter which two screw holes you choose. WARNING FAN FALL HAZARD Make sure screws are tight to secure the upper switch housing to the mounting plate. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 12 Tuck the excess wiring above the LED assembly. WARNING FAN FALL HAZARD Make sure screws are tight to secure the light fixture. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 13 GLASS FALL HAZARD To prevent SERIOUS INJURY or DEATH, make it is held tightly in place by the tabs. sure that glass is properly secured. NOTE: Check to ensure proper engagement M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 14 This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 15 Reference the included remote function card Installing the Wall Plate for information on how to use your wall control! Push the wall plate onto the Wall Plate Bracket. It should snap into place. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 16 Wall Control For Dual Switches www.CasablancaFanCo.com 1.888.227.2178 To install the Casablanca Wall Control into a dual switch location, Verify which switch controls the fan light. you will need a wall plate with both a standard switch and rocker Turn on power for the fan.
- Page 17 Reference the included remote function card provided wire nuts. for information on how to use your wall control! Push all wires into the switch box. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 18 Long Dimming Mode Long Press On/Off Fan Reverse Press Long Fan Updraft Press Long Fan Downdraft Press Power On/Off Long Pair Function Press Long Reset Press (For WiFi enabled fans ONLY) M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 19 Be sure to turn off power to the fan before performing any maintenance. Cleaning the fan - use soft brushes or cloths to prevent scratching. Cleaning products may damage the finishes. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 20 For the most updated list of will flash and stay on to indicate Casablanca Authorized Service successful pairing. Centers, visit www.CasablancaFanCo.com or call toll free 1-888-227-2178. M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...
- Page 21 “unpair” the remote. If applicable, the fan will turn off and the lights will turn on and the lights will flash and stay on to indicate successful pairing. will flash and turn off to indicate successful “unpairing.” M8552-01 • 03/04/19 • © 2019 Casablanca Fan Company...