Advertisement
Cot / Bassinet - Assembly
Assembly overview
Before commencing
assembly, note that
Alfresco cot can be
assembled as a full cot
with the base set in the
lower position; or as a
bassinet with the base
set in the high position.
Step 1-Attach support legs to end panels
Hardware needed
A:Camlock x 4
B:Locking pin x 4
1
Fit locking pins to end panels
Lay the end panel face down on the floor.
screw the locking pins(x2) into the threaded holes
Tighten firmly
2
Insert the camlock to support legs as shown.
3
Fit each support leg to the end panel as shown.
4
Cot
A
B
Step 2-Attach corner post to end panels
Hardware needed
A:M6 x 60mm connector bolts x 8
C
B:Camlock x 4
C:Locking pin x 4
Use camlock and locking pins attached
support leg to corner post
Attach the end panels to the base
Step 3 -
Hardware needed
M6 x 50mm Botls x 4
4 x lunar washers
M6 x 15mm cap bolts x 4
A). Attach each end panel
to the base. Note the
base position needed for either 'cot ' or 'bassinet'
configurations
To secure the base rails:
Insert a lunar washer to the locating hole at each end
of the base rails and then insert the connector bolts
and lightly hand tighten each connector bolt.
Do not fully tighten the bolts at this time.
B).IMPORTANT SAFETY STEP
Fit the small cap bolts to the 4
remaining unused base holes
(2 on each side).
A
B
B
A
B
A
5
Advertisement
