Table of Contents
Advertisement
Front-Panel
For
Recording IP
NACE: 610-429-1511 | sales@datatronix.biz | www.datatronix.biz | DT-HDIPUS Manual v1.0
Buttons/LEDs
Description
Reboot button
Reboots the device (unsaved settings will be lost)
To reset all the settings of the device to factory
default:
RST / UPG
To upgrade firmware using the USB port:
button
PWR
Power is ON
CFG
Indicates device is in configuration mode
USB
Indicates USB drive is mounted
MPEG-2
Indicates device is encoding video using MPEG-2
H.264
Indicates device is encoding video using H.264
MP2
Indicates device is encoding audio using MPEG-1 Layer 2
AAC
Indicates device is encoding audio using AAC
Dolby Digital
Indicates device is encoding audio using Dolby Digital
1. 1.Press and hold the RST/UPG button and then
connect power to the device while pressing in the
RST/UPG button.
2. 2.Hold the button until CFG led to flashes 10 times
(about 10 seconds)
3. 3.After the CFG led stops flashing -release the
button
1. 1.Plug-in the USB drive with the upgraded firmware
image ("hdip_upg.img")
2. 2.Press and hold the RST/UPG button and boot-up
the device
3. 3.USB led will flash while copying the image from
USB drive (about 3~5 seconds)
4. 4.Wait until the CFG led stop flashing
5. 5.Release the RST/CFG button and wait for the
device to reboot and upgrade the firmware (about 1
minutes)
Page 7
Advertisement
Table of Contents
