ABB EL3000 Series Manual page 114

114
Set the IP address in the computer
Establish and test the Ethernet connection
EL3000 CONTINUOUS GAS ANALYZERS
Start – Control Panel – Network and Sharing Center – Change adapter set-
tings – Right click on "Local Area Connection" – Properties: Select "Internet
Protocol Version 4 (TCP/IPv4)" – Properties – "General" tab: Use the follow-
ing IP address: – Enter IP address (see the following example).
Cable
Point-to-point connection: Twisted-pair cable with RJ45 connectors, termi-
nal layout: 1–3, 3–1, 2–6, 6–2
Connection via an Ethernet network: twisted-pair cable with RJ45 connect-
ors
The cables are standard Ethernet cables and are not part of the scope of
supply and delivery of the gas analyzer.
Test the Ethernet connection
To test the Ethernet connection, enter the following in the computer in
"Start – Execute...": "ping
gas analyzer). If the connection is OK, the gas analyzer reports "Answer from
IP address
: Bytes=32 Time<10ms TTL=255" (the numbers are de-
vice-specific). In the case of the message "Request timed-out", the connec-
tion is not OK.
The network name can also be entered instead of the IP address.
| CI/EL3000-EN REV. B
IP address IP address
" (with = IP address of the