Prime Solvent Flush Pump - Graco XP-hf 572407 Instructions Manual

Prime Solvent Flush Pump

Follow instructions if the solvent flush pump is used.
1. Connect a ground wire (not included) to a metal pail
of solvent.
2. Place the siphon tube and the solvent circulation
hose (BG) in the pail of solvent.
BG
3. Open the prime valve (BE) on the solvent pump
(BA) outlet.
4. Open the solvent pump air valve (DA). Slowly turn
the solvent pump air regulator (DB) clockwise to
prime the solvent pump and route solvent back to
the pail. Close the prime valve (BE) and solvent
pump air valve (DA).
DB
5. Open the solvent flush valve (AD) on the mix
manifold.
AB
3A4381M
6. Ensure the trigger lock is engaged. Remove the
7. Disengage the trigger lock and trigger the gun into a
BE
8. Open the solvent pump air valve (DA). Slowly turn
9. Close the solvent pump air valve (DA) and trigger
DA
AE
10. Close the solvent flush valve (AD).
(closed)
NOTE: Solvent pump air and pressure may be left on
while spraying.
AD
To prevent material from curing inside the system,
always prime the solvent pump and solvent hose with
solvent before spraying mixed materials.
spray tip.
TI1949a
grounded metal pail while holding against a pail.
Use a pail lid with a hole to dispense through. Seal
around the hole and gun with a rag to prevent
splash back. Be careful to keep fingers away from
the front of the gun.
TI1950a
the solvent pump air regulator (DB) clockwise to
prime the solvent pump and push air out of the mix
hose and gun. Trigger the gun until all air is purged.
the gun to relieve pressure. Engage the trigger lock.
Replace the spray tip.
DA
NOTICE
Prime Empty System
TI1949a
29