HireTech HT7 Manual

SPECIFICATION
This machine is suitable for use in sanding into the edge of areas not
accessible to a drum sander and for small floor areas
Power Supply: Electric Motor 240v.
Sending Disc: 7" Diameter
Noise: 100 dBa at 1m (3'3")
Motor: Continuous heavy duty AC self-cooling
4 Brush
IMPORTANT
PLEASE READ CAREFULLY
This machine is hired under terms & conditions of the Hire Contract.
No liability will be accepted for any damage caused to persons or
property through failure to observe operating and safety instructions.
A charge will be made for any damage caused to the machine
through misuse or failure to comply with operating instructions.
Hirers are also reminded that they are liable for the replacement cost
of any machine & accessories, lost or stolen.
BE SECURITY WISE - DO NOT TAKE ANY CHANCES
E&J HIRE
Tel: (01843) 868185
Mobile: 07745 409795
Online catalogue: www.ejhire.co.uk
EDGING SANDER
Model HT7 – 240V
CHECK THAT MACHINE SWITCHED OFF BEFORE PLUGGING IN
SAFETY NOTES
We strongly recommend using a residual current device with this
machine.
DO NOT expose machine to rain, or allow any contact with moisture. It
must be operated and stored in a dry environment.
CHECK that the operating voltage is correct before plugging in and that
any extension cables you supply / use, are in good condition / sufficient
rating.
DO NOT carry the machine by, pull on, or stress the power cable.
NEVER ALLOW children or anyone uninstructed to operate the machine.
KEEP ALL CHILDREN & PETS AWAY FROM MACHINE AND WORK
AREA.
ALWAYS SWITCH OFF and remove plug from socket before fitting
sanding discs, or cleaning etc.,
RECOMMENDED SAFETY WEAR facemask & ear defenders.
NEVER try to operate machine unless a sanding disc is fitted or continue
using with a damaged / worn disc.
STOP MACHINE IMMEDIATELY any damage to sanding disc or
machine is suspected.
ALWAYS renew dust bag before it is full:
Accumulations of mixtures of wood dust, previous finishes &
chemicals are liable to spontaneous combustion.
NEVER empty contents of bag into an open fire or incinerator as
explosive.
BE extremely careful that you do not sand over the power cables. If
suspected power cable damage, SWITCH OFF AND UNPLUG before
inspecting.
IF A FAULT develops; do not attempt any to repair.
Contact E&J HIRE Tel: 01843 868185