HireTech HT8 Owner's Manual & Operating Instructions
Drum floor sander
Hide thumbs
Also See for HT8:
- Owner's manual & operating instructions (26 pages) ,
- Owner's manual & operating instructions (18 pages) ,
- Owner's manual & operating instructions (18 pages)
Related Manuals for HireTech HT8
Summary of Contents for HireTech HT8
- Page 1 HSS2105 (L01A) HT8 DRUM FLOOR SANDER From Serial Number 07294 (240/240 Volt) & 03415 (110/120 Volt) OWNERS MANUAL & OPERATING INSTRUCTIONS 2018/09 © Hiretech Part # 163829...
-
Page 2: Table Of Contents
Hiretech Limited Warranty. WARNING: Risk of potential injury. Hiretech reserves the right to make changes or improvements to it’s products without prior notice. Moving Parts - to reduce the risk of injury, unplug the machine before replacing abrasive sheets or carrying out For the latest product news and updates, spare parts, downloads any form of adjustment or servicing. -
Page 3: Specification
18. If the machine should fail to operate refer to the Fault Finding notched and angled ends 24 Guide on page 10. to 120 grit. 19 The HT8 is heavy, take care when lifting and transporting the Power Cable 7m (23’) Non-marking outer machine. Always break down the machine into its component insulation. -
Page 4: Preparation
Always ensure that the floor sander is moving when in sander is now ready for use. operation and the sanding drum is in contact with the Note: Use Hiretech genuine floor sander abrasives for the best floor. sanding performance and finish. They will also reduce the risk of Never lift the back of the machine when sanding. -
Page 5: Floor Sanding Technique
If the floor is badly marked and scratched and When two thirds of the floor is sanded, turn the floor sander around has to be sanded back to new wood use the HT8-1.2 Floor Sander and sand the remaining third in the same way. Overlap the one and HT7-2 Disc Floor Sander. -
Page 6: Floor Sanding Tecnique
Use Hiretech abrasive pads to sand room. If there is no source of natural light sand in the direction of between each coat of varnish. The fine abrasive pads will remove... -
Page 7: Floor Sander Abrasive Guide
DO NOT OVER-SAND USE ONLY AS HEAVY GRADE ABRASIVE AS IT TAKES TO DO THE JOB. PROGRESS FROM FIRST GRADE USED THROUGH FOLLOWING GRADES TO REMOVE ALL VISIBLE SANDING MARKS. DO NOT MISS A GRADE. FLOOR SANDER ABRASIVES Hiretech Abrasives Hiretech recommend the following abrasive range which are suitable... -
Page 8: Service & Routine Maintenance
FAULT FINDING © Hiretech...
Need help?
Do you have a question about the HT8 and is the answer not in the manual?
Questions and answers