Subscribe to Our Youtube Channel
Related Manuals for HireTech HTF
Summary of Contents for HireTech HTF
- Page 1 HTF ORBITAL FLOOR & DECK SANDER From Serial Number 01407 (240/240 Volt) & 01181 (110/120 Volt) OWNERS MANUAL & OPERATING INSTRUCTIONS 2016/11 © Hiretech Part # 031390...
-
Page 2: Table Of Contents
Hiretech Limited Warranty. WARNING: Risk of fire. Hiretech reserves the right to make changes or improvements to it’s Never leave the floor sander unattended with dust in the products without prior notice. -
Page 3: Specification
SPECIFICATION SAFETY The HTF Orbital Floor & Deck Sander will sand wood floors and For safety it is recommended that a residual current circuit most types of decking, including fine parquet, engineered and pre- breaker (ground fault interrupter) is used with this machine. -
Page 4: Installing Abrasive
If the machine is tipped back when in operation the abrasive pad may become misaligned. PREPARATION Where possible remove all furniture from the room. The HTF-2 Floor Sander features an efficient dust pick-up, however, some dust will escape. Protect all vulnerable furnishings with dust sheets, masking films and tape. -
Page 5: Htf Sanding Weight
2. Stand in front of the HTF and rest the front edge of the weight ii. Never lift the back or front of the machine when sanding. onto the HTF base. Then tip the weight back so that the back iii. -
Page 6: Floor Sanding Technique
If the old finish is worn and Cover the same path you made on the forward cut by pulling the the floor is generally in good condition use the HTF-2 Floor Sander with Hiretech abrasive pads and strips which have been especially... -
Page 7: Floor Sanding Technique
© Hiretech... -
Page 8: Service & Routine Maintenance
ALL FOUR motor brushes when any one brush has worn to maintenance. 12mm (1/2”) or less in length. Brushes MUST slide freely in 2. The HTF-2 Floor Sander is subject to high speeds and the brush holders. vibration, all screws should be fitted using a suitable thread There is no need to remove or disconnect any internal leads lock compound. -
Page 9: Electrical Testing
The machine runs slow. The voltage is low. Check the supply voltage. If an extension lead is beingused, is it undersize and/or is it coiled. A motor brush is not making contact. Check and refit or replace the motor brushes. © Hiretech... -
Page 10: Parts Diagram
PARTS DIAGRAM HTF Orbital Floor & Deck Sander © Hiretech... -
Page 11: Parts Diagram
PARTS DIAGRAM HTF Orbital Floor & Deck Sander © Hiretech... -
Page 12: Parts List
Washer 030060 Retainer Wheel 030100 030320 Housing Eccentric 030600 Spring Plunger 030070 Wheel 030840 Screw 031420 Exhaust Guard 031650 Knob Assembly 031430 Ring Retainer 031370 Hook and Loop Pad 031310 Cap Weight 01769 Floor Sander Backing/Abrasive Pad HTF © Hiretech... -
Page 13: Circuit Diagram
Owners Manual & Operating Instructions Special Tools (not illustrated) 011740 Service Tool - Pinion & Pulley Fitting/Removal 031490 Service Tool - Lever Block Holder HTF 031610 Service Tool - Jacking Bolts HTF CIRCUIT DIAGRAM HTF Orbital Floor & Deck Sander © Hiretech... - Page 14 © Hiretech...
Need help?
Do you have a question about the HTF and is the answer not in the manual?
Questions and answers