Cisco CX-AIP-TM Installation And Configuration Manual page 51

Error Message
aip_setup_vc(ATM2/0): Return value 0
Explanation This is the return value from the AIP after a setup request.
Error Message
aip_teardown_vc(ATM2/0): Return value 0
The PVC teardown return code from the AIP. Return value 0 indicates successful
Explanation
operation.
Error Message
ATM(ATM2/0): Config. scaler error. RateQ 1, rate 1
Indicates that the rate specified for the peak rate is not allowable. The parser should
Explanation
catch most of these.
Error Message
aip_raw_input(ATM2/0): bad OAM type 0xaaaa
The system processor received an OAM cell with an invalid OAM type value.
Explanation
Error Message
aip_raw_input(ATM2/0): bad OAM function 0xaaaa
Explanation The function value in the OAM cell is invalid in one of the following:
•
F4 SEGMENT
•
F4 END-to-END
•
F5 SEGMENT
•
F5 END-to-END
Error Message
atm_pakalign(ATM2/0): Invalid VC(65535) received, type=0xaaaa
A packet was received by the AIP with a VC that is out of the valid range of VCs.
Explanation
Error Message
atm_pakalign(ATM2/0): VC(1) NOT configured, type=0xaaaa
Explanation A packet was received by the AIP for which a VC is not configured.
Error Message
ATM(ATM2/0): Encapsulation error, link=0xaaaa, host=0xaaaa
The ATM software failed to encapsulate a protocol because the protocol address is
Explanation
not in a STATIC map table.
Asynchronous Transfer Mode Interface Processor (AIP) Installation and Configuration
Interpreting ATM Error Messages
51