Table of Contents
Advertisement
ATM Interface Cables
Following are descriptions of the network interface cables used with the AIP.
•
Figure 9
•
Figure 10
Figure 11
•
Figure 12
Warning
products when no fiber-optic cable is connected. Avoid exposure and do not stare into open
apertures. This product meets the Class 1 Laser Emission Requirement from CDRH FDDI.
24 Asynchronous Transfer Mode Interface Processor (AIP) Installation and Configuration
For TAXI 4B/5B traffic over multimode fiber, use the multimode MIC interface cable to connect
the AIP with the external ATM switch. (See Figure 9.)
Multimode Network Interface Connector (MIC Type)
For SONET/SDH multimode connections, use one multimode duplex SC connector (see
Figure 10) or two single SC connectors (see Figure 11).
Duplex SC Connector
Simplex SC Connector
For SONET/SDH single-mode connections, use the single-mode (ST2) connector (bayonet-style
twist-lock). (See Figure 12.)
ST2 Connector
Invisible laser radiation can be emitted from the aperture ports of the single-mode ATM
Advertisement
Table of Contents
