Table of Contents
Advertisement
Using show Commands to Check the Configuration
Following are descriptions and examples of the show commands that display AIP configuration
information:
•
Use the show controllers cbus command to display the internal status of the system processor
and each interface processor, including the interface processor slot location, the card hardware
version, and the currently-running microcode version. The show controllers cbus command also
lists each interface (port) on each interface processor, including the logical interface number,
interface type, physical (slot/port) address, and hardware (station address) of each interface. The
following examples show an AIP installed in interface processor slot 0, the running AIP
microcode is Version 170.46, the PLIM type is 4B/5B, and the available bandwidth is 100 Mbps:
Router# show cont cbus
(additional displayed text omitted from this example)
•
Use the show interfaces atm slot/port command to display statistics for the ATM interface you
specify by its interface address, as follows:
Router# show int atm 0/0
ATM interface ATM0/0:
AAL enabled: AAL5, Maximum VCs: 1024, Current VCs: 6
Tx buffers 256, Rx buffers 256, Exception Queue: 32, Raw Queue: 32
VP Filter: 0x7B, VCIs per VPI: 1024
PLIM Type:4B5B - 100Mbps, No Framing, TX clocking: LINE
4897 input, 2900 output, 0 IN fast, 0 OUT fast
Rate-Queue 1 set to 100Mbps, reg=0x4EA
Config. is ACTIVE
AIP 4, hardware version 1.0, microcode version 170.46
Microcode loaded from system
Interface 32 - ATM0/0, PLIM is 4B5B(100Mbps)
15 buffer RX queue threshold, 36 buffer TX queue limit, buffer size 4496
ift 0007, rql 12, tq 0000 0620, tql 36
Transmitter delay is 0 microseconds
Asynchronous Transfer Mode Interface Processor (AIP) Installation and Configuration
Configuring the AIP
41
Advertisement
Table of Contents
