Table of Contents
Advertisement
Configuring the AIP
AIP Statistics
The AIP will maintain a count of certain errors. In addition to keeping a count of these errors, the
AIP will also take a snapshot of the last VCI/VPI that caused an error. Each AIP error counter is 16
bits.
Errors include the following:
•
•
•
•
•
•
ATM show Commands
You can use the following ATM show commands to display the current state of the ATM network
and the connected VCs:
•
•
•
•
40 Asynchronous Transfer Mode Interface Processor (AIP) Installation and Configuration
CRC errors
Giants received
No buffers available
Framing errors
Applique/physical layer errors
Packet timeout errors on receive
To show current VCs and traffic information, use the show atm vc command, as follows:
Router# show atm vc [vcd]
Specifying a VCD displays specific information about that VCD.
To show current ATM-specific information about the AIP interface, use the show atm int
interface command, as follows:
Router# show atm int interface
To show current ATM traffic, use the show atm traffic command, as follows:
Router# show atm traffic
The show atm traffic command displays global traffic information to and from all ATM
networks connected to the router.
To show the current ATM mapping of the active list of ATM static maps to remote hosts on an
ATM network, use the show atm map command, as follows:
Router# show atm map
Advertisement
Table of Contents
