Advertisement
Failure to operate your model in a safe and responsible manner may result in property damage and serious injury. The
precautions outlined in this manual should be strictly followed to help ensure safe operation. You alone must see that the
instructions are followed and the precautions are adhered to.
Important Points to Remember
• Your model is not intended for use on public roads or congested areas where its operation can conflict with or disrupt
pedestrian or vehicular traffic.
• Never, under any circumstances, operate the model in crowds of people. Your model could cause injury if allowed to collide
with anyone.
• Because your model is controlled by radio, it is subject to radio interference from many sources that are beyond your control.
Since radio interference can cause momentary loss of radio control, always allow a safety margin in all directions around the
model in order to prevent collisions.
• The motor, battery, and speed control can become hot during use. Be careful to avoid getting burned.
• Don't operate your model at night, or anytime your line of sight to the model may be obstructed or impaired in any way.
• Most importantly, use good common sense at all times.
Speed Control
Your model's electronic speed control (ESC) is an extremely powerful electronic device capable of delivering high current.
Please closely follow these precautions to prevent damage to the speed control or other components.
• Disconnect the Battery: Always disconnect the battery from the speed control when not in use.
• Insulate the Wires: Always insulate exposed wiring with heat shrink tubing to prevent short circuits.
• 6-7 NiMH cells or 2-3 LiPo cells (2s/3s): The ESC can accept a maximum input voltage of 8.4 volts (NiMH) or 11.1 volts (3s
LiPo). Always adhere to the minimum and maximum limitations of the ESC as stated in the specifications table.
• Transmitter on First: Switch on your transmitter first before switching on the speed control to prevent runaways and erratic
performance.
• Don't Get Burned: The ESC and motor can become extremely hot during use, so be careful not to touch them until they cool.
Supply adequate airflow for cooling.
• Use the Factory-Installed Connectors: Do not change the battery and motor connectors. Improper wiring can cause fire or
damage to the ESC.
• No Reverse Voltage: The ESC is not protected against reverse polarity voltage.
Recycling RC4WD 6-Cell 3000mAh NIMH Battery Pack
RC4WD strongly encourages you to recycle RC4WD 6-Cell 3000mAh NIMH Battery Pack batteries when they reach the end
of their useful life. Do not throw batteries in the trash. All RC4WD 6-Cell 3000mAh NIMH Battery Packs display the RBRC
(Rechargeable Battery Recycling Corporation) icon, indicating they are recyclable. To find a recycling center near you, ask
your local hobby dealer or visit
www.call2recycle.org
Your model is able to use LiPo batteries.
Charging and discharging batteries has the potential for fire, explosion, serious injury, and property damage if not performed
per the instructions. Before use, read and follow all manufacturer's instructions, warnings, and precautions. In addition, Lithium
Polymer (LiPo) batteries pose a SEVERE risk of fire if not properly handled per the instructions and require special care and
handling procedures for long life and safe operation. LiPo batteries are intended only for advanced users that are educated on
the risks associated with LiPo battery use. RC4WD does not recommend that anyone under the age of 14 use or handle LiPo
battery packs without the supervision of a knowledgeable and responsible adult. Dispose of used batteries according to the
instructions.
3
Advertisement
