Advertisement
Quick Links
Advertisement
Related Manuals for RC4WD JDM 158
Summary of Contents for RC4WD JDM 158
- Page 1 JDM 158 1/14 Overland 6x6 RTR RC Truck w/ Utility...
-
Page 2: Warranty
Warranty FCC and Regulatory Compliance FCC Compliance: This device contains a module that complies with the limits for a Class B digital device as described in part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 3 LiPo batteries are intended only for advanced users that are educated on the risks associated with LiPo battery use. RC4WD does not recommend that anyone under the age of 14 use or handle LiPo battery packs without the supervision of a knowledgeable and responsible adult.
- Page 4 Important Warnings for users of Lithium Polymer (LiPo) batteries: • LiPo batteries have a minimum safe discharge voltage threshold that should not be exceeded. The electronic speed control is equipped with built-in Low-Voltage Detection that stops the vehicle when LiPo batteries have reached their minimum voltage (discharge) threshold.
- Page 5 • DO NOT disassemble, crush, short circuit, or expose the batteries to flame or other source of ignition. Toxic materials could be released. If eye or skin contact occurs, flush with water. • If a battery gets hot to the touch during the charging process (temperature greater than 110°F / 43°C), immediately disconnect the battery from the charger and discontinue charging.
- Page 7 Scale: 1:14 Size: length 734, width 230, height 273 (excluding antenna 233), unit MM Wheelbase: Total wheelbase 482, front axle to middle axle 367, middle axle to rear axle 115, unit MM Front shock absorber stroke: 20 MM Battery specifications: 3S, 5200mAh, 11.1V, 25C or more; Battery compartment size: 142 * 45 * 40MM (battery size can be within this range) Weight: 6.8KG, plus controller 7.1KG Theoretical load: 10KG...
- Page 8 Total mass for load: 17KG Controller: Radio RC4GS Note: The controller uses 6 AA batteries, the main truck battery is 11.1V3S lithium battery or 12V battery, and the battery connector is XT60. Operation steps: 1. Turn on the controller (the switch or knob of the controller should be in the default position) 2.
- Page 9 Installing front bumper:...
-
Page 11: Installing The Windshield
Installing the windshield... - Page 12 Installing the antenna: Installing the headlight grille and the side light grille:...
- Page 13 Installing snorkel cap: Installing right rearview mirror:...
-
Page 14: Installing Battery
Installing battery:... -
Page 15: Door Opening
Door opening... - Page 16 Rear bed opening: 1. open the rear bed 3.Open the tailgate of the 2.Turn the rear bed hook rear bed 180 degrees up...
- Page 17 5. Turn the rear bed hook 180 4.Open the front panel: Degrees upward: 7.The schematic diagram 6. Open the left and right of opening: Degrees upward: side of the panels:...