Led Indicators - Notifier ACPS-2406 Manual

LED Indicators

1.6 LED Indicators
There are 16 LEDs that indicate various conditions and troubles. The following table lists and
describes each.
Reference
D19
D32
D40
D47
D54
D81
D66
D67
D68
D69
D70
D71
D72
D75
D73
D74
ACPS-2406 PN 51304:B 09/02/2003
LED Name Color
GND FLT Yellow
NAC 1 Activated Green
NAC 2 Activated Green
NAC 3 Activated Green
NAC 4 Activated Green
MONITOR Green
NAC 1 Green
NAC 2 Green
NAC 3 Green
NAC 4 Green
TRBL Yellow
BAT/CHG Yellow
UCFAILURE Yellow
AC Green
SLCRXA Green
SLCTXA Green
Table 1.2 LED Indicators
Description
Illuminates when a ground fault is detected on any NAC,
battery lead, or 24-volt output.
Illuminates when NAC 1 is activated.
Illuminates when NAC 2 is activated.
Illuminates when NAC 3 is activated.
Illuminates when NAC 4 is activated.
Blinks steadily during normal polling process. Shuts off
when there is a monitor trouble.
Glows steadily when communication is established with the
FACP. Blinks steadily during normal polling process.
Glows steadily when communication is established with the
FACP. Blinks steadily during normal polling process.
Glows steadily when communication is established with the
FACP. Blinks steadily during normal polling process.
Glows steadily when communication is established with the
FACP. Blinks steadily during normal polling process.
Illuminates when one of the following troubles occur: brownout;
+38 volt supply supervison; invalid address.
Blinks once, pauses, then blinks again, repeating this pattern for
brownout trouble.
Blinks twice, pauses, then blinks twice again, repeating this
pattern for +38 volt supply failure.
Blinks three times, pauses, then blinks three times again, repeating
this pattern. Panel programming does not match DIP Switch
settings.
Illuminates when there is a battery or charger trouble.
Illuminates if the microcontroller fails.
Illuminates when there is AC power.
Illuminates when data is transmitted on the SLC.
Illuminates when data is received from the SLC.
Introduction
11