Genesis 2 Series Manual page 7

Installation
- Final Checkout -
1. Be certain that the bypass valve is in Service position and main valve is completely on.
2. Check electrical supply to be certain the cord is connected to an uninterrupted 115 volt outlet.
IMPORTANT NOTICE - The plumbing system, piping, pressure tank, hot water tanks, softeners, etc. that have been
exposed to iron bearing water may need to be cleaned of the precipitated iron that has been collected in them or iron
bleed thru may be a problem. We suggest all tanks be drained and flushed thoroughly.
- Annual Maintenance –
Annual replacement of the seal kit is recommended in all single tank air systems due to air drying of the seals over time.
Potential performance issues will result if this maintenance interval is not performed. Any system problems associated
with this recommended system maintenance not being accomplished will not be covered by the factory warranty.
7