Programming The Control Valve - Genesis 2 Series Manual

Chemical free iron and hydrogen sulfide filtration system

Hide thumbs Also See for 2 Series:

Owner's manual (8 pages)

Owners manual and set-up manual (18 pages)

Table Of Contents

Table of Contents

Normal Operation

1. Home Display

a. Alternates between the display of Time of Day and Number of Days until the Next

Backwash. (Metered softeners will alternate between time of days and gallons remaining until next regeneration)

- Days Remaining until the Next Backwash will count down from the entered value until it reaches 1 day

remaining.

- A Backwash Cycle will then be initiated at the next designated regeneration time.

2. Battery Back-Up (Uses a standard 9-volt alkaline battery.)

Features of Battery Back-Up:

• During power failures, the battery will maintain the time of day as long as the battery has power. The

display is turned off to conserve battery power during this time. To confirm that the battery is

working, press either button and the display will turn on for five (5) seconds.

• If power failure occurs while system is regenerating, the Signature 2 will motor to a shut off position

to prevent constant flow to drain. After power is restored, the Signature 2 will return and finish the

cycle where it left off prior to the power interruption.

• When used without battery back-up, during a power failure, the unit stops at its current point in the

regeneration position and then restarts at that point when the power is restored. The time will be

offset by the increment of time the unit was without power, so it is necessary to reset the time of day

on the unit. No other system settings will be affected.

Starting Extra Regeneration Cycle

1. To Start Delayed Extra Cycle

If Days Remaining Until Next Regeneration does not read '1', press and hold the

Set/Change button for 3 seconds until the display reads '1

Regeneration cycle will initiate at the next designated regeneration time.

2. To start Immediate Extra Cycle

Press and hold the Set/Change button.

After 3 seconds, the regeneration cycle will begin.

3. To Fast Cycle thru regeneration

Press and hold the Set/Change button for 3 seconds to advance to the next cycle step.

Note: Fast Cycle is not necessary unless desired to manually step through each cycle

step.(Repeat until valve returns to the home display)

Regeneration Cycle

(do not change)

First complete above step.

First complete above 2 steps.

Nitro

Default Cycle Step Times

Step 1

Air Release (non-adjustable)

Step 2

Backwash

Step 3

Rest

Step 4

Air Replenish

Step 5

Rapid Rinse