2. If applicable,
remove the drive
blank.
Steps
1. Press the release button on the front of the drive carrier to open the release handle.
2. Insert and slide the drive carrier into the drive slot.
3. Close the drive carrier release handle until it clicks in place.
Figure 28. Installing a drive carrier
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in
Safety
instructions.
CAUTION:
Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2. Lift the drive out of the drive carrier.
Installing and removing enclosure components
43