Table of Contents
Advertisement
3.
Click the General tab.
4.
In the Operation Mode field select Maintenance. Selecting Maintenance isolates alerts from those that would occur during
normal operation.
5.
Click OK.
Replacing the Front Bezel
The front bezel is a cover for the front panel of the expansion enclosure.
About this task
The front bezel must be removed from the front panel when replacing hard drives.
Steps
1.
Use the system key to unlock the keylock at the left end of the bezel.
2.
Lift the release latch next to the keylock.
3.
Rotate the left end of the bezel away from the front panel.
4.
Unhook the right end of the bezel and pull the bezel away from the expansion enclosure.
Figure 6. Replacing the Front Bezel
5.
Hook the right end of the replacement bezel onto the front panel of the expansion enclosure.
6.
Insert the left end of the bezel into the securing slot until the release latch locks into place.
7.
Secure the bezel with the keylock.
Replacing Hard Drives
The SCv300 and SCv320 expansion enclosures supports hot-swappable hard drives.
The SCv300 expansion enclosure supports up to 12 3.5-inch hard drives installed in a four-column, three-row configuration. The
SCv320 expansion enclosure supports up to 24 2.5-inch hard drives installed vertically side-by-side. . Hard drives are connected to a
backplane through hard drive carriers. Hard drive blanks are installed in the hard drive bays that are not occupied.
NOTE: One spare drive is allocated for every 20 drives in the expansion enclosure.
SCv300 and SCv320 Expansion Enclosure Drive Numbering
Drives are numbered from left to right in the SCv300 and SCv320 expansion enclosure.
The Storage Center identifies drives as XX-YY, where XX is the unit ID of the expansion enclosure, and YY is the drive position inside
the expansion enclosure.
•
The SCv300 holds up to 12 drives, which are numbered from left to right in rows starting from 0 at the top-left drive.
11
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
