Dvi Anallog Cable; Computer In 2 Connector; Contents - Toshiba TLP780U Owner's Manual

Connecting a computer
You can project the picture of analog RGB or digital RGB signal from a computer by using COMPUTER IN 2 connector.
Check that the power for the projector and computer is off before connecting the cables.
USB MONITOR
OUT
CONTROL
Notes
(Please also read "Notes" on page 22.)
• DVI digital cable should be purchased separately when you input a digital RGB signal.
• Although infrequent, noise might be generated on the screen depending on the type of computer and the connection cables. Should this occur, reduce
the refresh rate of the computer signal, or lower the resolution. Use of connection cables that are 2 m or shorter is recommended.
• The input signal specifications of the DVI port of the projector conform to DVI 1.0 specifications; however, contents protection is not supported. Note
that there is no guaranty of the operations not specified in this specifications.
COMPUTER IN 1 COMPUTER IN 2
( Y/P )
/P
B R
AUDIO VIDEO IN
IN R - AUDIO - L VIDEO S-VIDEO
To COMPUTER IN 2 Connector
Be sure to connect in the proper
direction.
DVI analog cable
To AUDIO IN jack
Audio cable (Supplied)

(COMPUTER IN 2 connector)

COMPUTER IN 2 Connector (DVI connector)
For use as both Analog RGB (2) input and Digital RGB input. At shipping
from factory, it is set for use as Analog RGB (2) input. Change the setting on
the menu screen when using as Digital RGB input.
AUDIO IN jack
For use as both audio signals for RGB input (analog RGB (1)/analog RGB
(2)/digital RGB) and Y/P /P
B
Connecting a Mac adapter for
Macintosh computers (Supplied)
To monitor port
(Supplied)
45
input.
R
Computer
3.5mm Stereo mini-jack
To audio output port
Continued
23

CONTENTS