Keystone Setting (1); Drive Setting (Dvi Signal) - Toshiba TLP-X10U Service Manual

5-3-2. Keystone setting (1) (In case of Main PCB was changed.)
Step Figure
1

5-3-3. Drive setting (DVI signal)

Step Figure
1
2
3
(1) Select "Keystone1" step.
(2) Set the projector horizontally, and click [KC0] button.
(3) Set the projector to a +30 degree angle, and click the
[KC1] button.
(4) Set the projector to a -30 degree angle, and click [KC2]
button.
(5) Press [Next] button.
[Note]
* A green button is available.
* All the data is saved, when [Next] button is pushed.
Use the extension cable kit.
(1) Select "Drive" step.
(2) Press [Start] button.
(1) Monitor the waveform at the respective test point ("TP-
RIN" when you adjust the R level).
(2) When the [WN7] button is clicked, you enter the "R"
adjustment mode.
(3) Click [+] or [-] button to adjust the signal level.
(4) Adjust "G" and "B" colors to be the same.
(5) Click [Next] button to proceed to the next adjustment.
1-39
Explanation
Explanation