Coarse Pointing - Hughes HughesNet Ka-band Pointing Manual

Coarse pointing

This section describes each phase of the coarse pointing process
and the messages that appear on the DAPT display screen during
the procedure.
1. At the ODU, install the DAPT in line with the low-noise
block (LNB) converter on the receive cable as shown in
Figure 7. Be sure to connect the cables to the DAPT in
accordance with the connector labels on the DAPT rear panel
(not shown).
Note: You must also ensure that the transmit cable is
connected between the SAT OUT connector on the IDU and
the IFL connector on the ODU radio transmitter.
Figure 7: Installing the DAPT
Chapter 2 • Pointing the antenna
1037663-0001 Revision A
13