Connection; Turning The Power On And Off - Toshiba TLP-T50M Owner's Manual

Connection

Before connection
• Read the owner's manual of the device to be connected to the projector.
• Some types of computer cannot be used connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connection.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
CRT monitor, etc.
Audio cable
(for computer)
(supplied)
VIDEO
CONTROL AUDIO MONITOR
VIDEO S-VIDEO
Control cable
Yellow
(to video output)
p.38
To audio
output
To RS-232C terminal
White (L)
Red (R)
Computer (for control)
Note
• The AUDIO terminal is common among all the devices for input terminal.
p.36 , etc.
Computer
To audio output
To RGB
output
RGB cable
(supplied)
COMPUTER
( Y/P /P )
B R
Monitor cable
Mini D-sub 15P-BNC
(not supplied)
Audio cable
(supplied)
To Y/C
S-Video cable
output
(not supplied)
Green (Y)
Blue (C
Video cable
Red (C
(supplied)
To audio
Conversion adapter
output
To S-Video
BNC-pin
White (L)
output
(not supplied)
Red (R)
VCR DVD player
18

Turning the power on and off

Connecting the power cord
1
Insert the power cord connector into the AC IN socket of the projector.
2
Insert the power cord plug into a wall or other power outlet.
(Supplied) Power cord connector
Removing the lens cover
Turning the power on
Press the ON/STANDBY
button.
The power turns on, and the
following 3 green indicators light:
ON, LAMP, and FAN. After a
moment, the start-up screen
appears.
/C
B R
),
B
CAUTION
)
R
• Do not look into the lens during operation. Doing so could damage your vision.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal
overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could
cause burns, deform/break the object.
Notes
• The start-up screen will disappear after a moment. You can dismiss the start-up screen
before this by performing any operation. You can also configure the start-up screen not to
appear via the Display setting menu
• The first time you use the projector after purchase, after the start-up screen disappears,
the Language menu is displayed
When the power cord is plugged in, the following three
green indicators will come on for several seconds: ON,
TEMP, and LAMP. Next, the ON indicator will change to
orange, indicating standby mode.
(Do not perform any operations while the 3 green
indicators are lit.)
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
Remote
Control panel Control
FAN TEMP LAMP ON
ON/
CALL STANDBY
INPUT ON / STANDBY
KEYSTONE AUTO SET
MUTE FREEZE
MENU
RESIZE
- +
VOL. VOL.
RESIZE
OFF
AUTO
KEYSTONE AUTO SET
INPUT
p.29 .
p.21 .
19
Start-up screen