Table of Contents
Advertisement
Connection
Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Computer (for control)
VCR
To audio output
To video
To
White (L)/Red (R)
output
White (L)/Red (R)
p.71
RS-232C
Video cable
terminal
(not supplied)
Control cable
AV cable
(not supplied)
Audio cable
(not supplied)
RGB cable
(not supplied)
To RGB
output
To audio
output
Computer
DVD video recorder, etc.
Notes
• COMPUTER terminals 1 and 2 function identically.
• The AUDIO IN terminal doubles for devices connected to COMPUTER terminals 1 and 2.
p.69
, etc.
Audio amplifier, etc.
Video recorder,
DVD player, etc.
To audio output
To S-Video
To audio input
output
White (L)/Red (R)
Audio cable (not supplied)
S-Video cable
(not supplied)
RGB cable
Audio cable
(supplied)
(not supplied)
Monitor cable Mini
D-sub 15P-BNC
To RGB
(not supplied)
To audio output
output
To Y/C
/C
output
B
R
Green (Y)/Blue (C
)/Red (C
)
B
R
Conversion adapter BNC-pin
(not supplied)
Computer
20
How to use the PC card slot
The wireless LAN PC card enables you to connect the projector wirelessly with a personal
computer that supports IEEE802.11b based wireless LAN.
nication between all the computers based on IEEE802.11b and this projector is not
guaranteed.) You can also use a commercially available memory card to project JPEG
image files using this projector.
p.42
Please follow the steps below when removing or
mounting a PC card.
Mounting a PC card
q Insert the PC card.
After making sure of the card orienta-
tion, press it in firmly until it stops.
PC Card
When the PC card is detected correctly,
the CARD indicator comes on in green.
If CARD indicator turns red
Press the RESET switch with a thin pin
or similar implement (it is at the bottom
of a recess).
(Please note that commu-
p.34
Removing a PC card
q Look at CARD indicator.
If it is off, proceed to step r.
CARD indicator
UNMOUNT button
w Press the UNMOUNT button.
Begins processing for PC card removal.
e Wait until CARD indicator goes
out.
Never remove the PC card while lit.
Doing so could damage the PC card or
corrupt your data.
r Press the Eject button.
Eject button
The Eject button is a bit stiff, so
press firmly while supporting the
projector. Be careful to avoid injury
when doing so.
CARD indicator
RESET switch
21
Advertisement
Table of Contents
