Table Of Contents - Cisco PA-MC-T3 Installing And Removing

Port Adapter Removal and Installation
Port Adapter Removal and Installation
In this section, the illustrations that follow give step-by-step instructions on how to remove and install
port adapters. This section contains the following illustrations:
•
•
•
•
•
•
•
•
•
•
The PA-MC-T3 port adapter can be installed in port adapter slots 0 or 1 on the Catalyst RSM/VIP2
Note
motherboard, the Catalyst 6000 family FlexWAN module, or the VIP and in any available port adapter
slot in all other systems.
Each port adapter circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge
Caution
(ESD) damage.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the midplane with your hand or any metal tool, or you could shock yourself. Statement 181
Tip If a port adapter lever or other retaining mechanism does not move to the locked position, the port
adapter is not completely seated in the midplane. Carefully pull the port adapter halfway out of the slot,
reinsert it, and move the port adapter lever or other mechanism to the locked position.
To prevent jamming the carrier between the upper and the lower edges of the port adapter slot, and to
Caution
ensure that the edge connector at the rear of the port adapter mates with the connection at the rear of the
port adapter slot, make certain that the carrier is positioned correctly, as shown in the cutaway in the
following illustrations.
PA-MC-T3 Port Adapter Installation and Configuration
3-4
Catalyst RSM/VIP2-Removing and Installing a Port Adapter, page 3-5
FlexWAN Module-Removing and Installing a Port Adapter, page 3-6
Cisco 7200 Series Routers and Cisco 7200 VXR Routers-Removing and Installing a Port Adapter,
page 3-7
Cisco uBR7200 Series Routers-Removing a Port Adapter, page 3-8
Cisco uBR7200 Series Routers-Installing a Port Adapter, page 3-9
Cisco 7201 Router-Removing and Installing a Port Adapter, page 3-10
Cisco 7301 Router-Removing and Installing a Port Adapter, page 3-11
Cisco 7304 PCI Port Adapter Carrier Card-Removing and Installing a Port Adapter, page 3-12
Cisco 7401ASR Router-Removing and Installing a Port Adapter, page 3-14
VIP-Removing and Installing a Port Adapter, page 3-15
Chapter 3 Removing and Installing Port Adapters
OL-2695-05