Cisco PA-MC-T3 Installing And Removing page 17

Chapter 3 Removing and Installing Port Adapters
To prevent system problems and to maintain the proper cable connection sequences, connect the RX and
Caution
TX ports on your PA-MC-T3 as indicated in Step 2.
Attach the network ends of your two 75-ohm coaxial cables to your external T3 equipment as follows:
Step 2
Attach the coaxial cable from the PA-MC-T3 TX port to the RX port on your external T3 equipment.
•
Attach the coaxial cable from the PA-MC-T3 RX port to the TX port on your external T3 equipment.
•
This completes the procedure for attaching 75-ohm coaxial cables to a PA-MC-T3. Proceed to
"Configuring the PA-MC-T3"
OL-2695-05
to configure the interfaces on the PA-MC-T3.
PA-MC-T3 Port Adapter Installation and Configuration
Connecting a PA-MC-T3 Cable
Chapter 4,
3-17