Chapter 2. Installing The San Volume Controller 2145-Cf8 Hardware; Installing The Cable-Management Arm For The San Volume Controller 2145-Cf8 - IBM 2145-CF8 Hardware Installation Manual
System storage san volume controller errata
Hide thumbs
Also See for 2145-CF8:
- Hardware maintenance manual (334 pages) ,
- Hardware maintenance manual (372 pages) ,
- Hardware installation manual (101 pages)
Advertisement
Chapter 2. Installing the SAN Volume Controller 2145-
CF8 Hardware
Installing the cable-management arm for the SAN Volume
Controller 2145-CF8
The text and diagrams below replaces the figure and paragraph
Page 28, Fig 26 and Para 4
The cable management support arm or tie bar has been modified since the initial
shipment in that it now has the two locating pins on the same side of the arm.
The procedure for the left side attachment in diagram 1 below is unaltered. The detailed
view is looking from inside the rack for clarity of detail.
The right hand side of the arm in diagram 1 requires that the arm is connected in into the
top of the lower locating hole, steps 4,5 and 6, the opposite to the previous instruction.
Note that the angle between the two parts at assembly is important. Then insert the
bracket into the rail after pulling the blue pin, steps 7 and 8.
© Copyright IBM Corp. 2009, 2010
7
Advertisement
