I Iaqualink™ Control - Zodiac ALPHA iQ iAquaLink CONTROL Instructions For Installation And Use Manual

4.2 I iAquaLink™ control
Before controlling the cleaner with the applicati on, take care to:
• Connect the control box to a power outlet,
• Immerse the cleaner in the pool.
4.2.1 Programming and controlling cleaning cycles
From the applicati on:
• Start, stop cleaning;
• View the current cycle's remaining cleaning ti me (displayed in hours and minutes);
• The remaining ti me is not displayed during the fi rst Smart mode cycle. The fi rst Smart cycle is used to
"inspect" the pool to determine opti mal cleaning ti me. This opti mized cleaning ti me is displayed from the
2nd cycle, and shows how much cleaning ti me remains.
• Increase, reduce the cleaning ti me by sequences of 15 minutes (depending on model);
• Choice of pre-set cleaning modes: Quick cleaning, Smart cleaning, Ultra cleaning, Water line only cleaning (depending
on model);
• The new cleaning mode will take eff ect for the cleaning cycle in progress and all future cycles.
• The cleaning cycle ti me may vary depending on the selected setti ngs.
• Schedule cleaning cycles (days and hours) (depending on model); Cleaning cycles may be programmed to repeat,
only one program can be set per day;
• Check the pool's temperature during the cleaning cycle (depending on model);
The cleaner measures the water temperature while operati ng.
• When the cleaner is at the bott om of the pool, it is normal to see a diff erence between the temperature
measured by the cleaner and the temperature measured by a thermometer placed on the pool's surface,
or which is measured by another device.
4.2.2 "Lift System" functi on for helping to remove the cleaner from the water
The "Lift System" functi on was designed to facilitate removing the cleaner from the water. It may be acti vated at any
ti me, during or at the end of a cleaning cycle.
• Only acti vate the Lift System functi on if the cleaner is in view.
• To guide the cleaner to the required wall, use the right or left arrow;
• When the cleaner is opposite the wall, press the "Lift System" butt on
pool wall and climb to the waterline;
• Using the handle, lift the cleaner from the water. At this point, the cleaner will expel a powerful jet of water. It will
then be lighter to lift from the pool.
• Fully remove the cleaner from the water.
• Do not pull on the fl oati ng cable to lift the cleaner out of the water; use the cleaner's
handle.
• You are strongly encouraged to remove and clean the fi lter aft er each cleaning cycle.
. The cleaner will start to move to the
EN
14