Safety Information; Safety Warnings; Preliminary Recommendations; General Information - WEG CFW100 Installation, Configuration And Operations Manual

1 SAFETY INFORMATION

1.1 SAFETY WARNINGS

NOTE!
Only use the I/O expansion module
„
(CFW100-IOAR) on WEG CFW100 series
inverters with firmware from version V2.0X
up (see P023).
It is recommended to read the CFW100
„
user manual before installing or operating
this accessory.
This guide contains important information
„
regarding the proper understanding and
correct operation of this module.

1.2 PRELIMINARY RECOMMENDATIONS

ATTENTION!
Always disconnect the general power
„
supply before connecting or disconnecting
the accessories of the CFW100 frequency
inverter.
Wait for at least ten minutes for the full
„
discharge of the power capacitors.

2 GENERAL INFORMATION

This guide provides directions for the installation,
configuration and operation of the I/O expansion module
(CFW100-IOAR).

3 CONTENT OF THE PACKAGE

Upon receiving the product, check if the package
contains:
Accessory in anti-static package.
„
Installation, configuration and operation guide.
„

4 INSTALLATION OF THE ACCESSORY

The CFW100-IOAR is easily connected to the CFW100
frequency inverter by means of the plug-and-play
concept. The procedures below must be observed for
I/O Expansion Modules
CFW100 | 5