TEC B-450-QP SERIES Owner's Manual page 27

Thermal printer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
12. TROUBLESHOOTING
Error type
CUTTER ERROR
Paper is jammed in the cutter.
Other Error
Hardware or software trouble.
NOTE:
If an error cannot be cleared by pressing the [PAUSE] key, the power must be switched off
then on again.
Once the power has been switched off and on, all the print data in the printer is cleared.
Problem
No print.
Dots missing in the
print.
Unclear (or blurred)
printing.
Power does not come
on.
Printer does not cut.
You see a raised nap
where the paper has
been cut.
Problem
1. Check that the paper and ribbon are loaded correctly.
2. Check that print head is set correctly.
3. Check the cabling between the printer and the host.
Dirty print head.
Clean the print head.
Call your Authorised Service representative if necessary.
1. Dirty print head.
2. Bad or faulty ribbon.
3. Poor paper quality.
1. Plug power cord into an AC socket.
2. Check the circuit breakers or fuses.
3. Plug another appliance into the AC socket to check if there is power
supplied.
Call your Authorised Service representative if necessary.
Check for a paper jam in the cutter.
Call your Authorised Service representative if necessary.
1. Clean the cutter blades.
2. The blades are worn.
Call your Authorised Service representative.
E12-2
Remove the jammed paper and feed
the undamaged media through the
cutter (See page 11-3).
Press the [PAUSE] key.
Else
Turn the power off and contact your
Authorised Service representative.
Turn the power off then on again. If
the problem still exists turn the power
off and contact your Authorised Ser-
vice representative.
Solution
Clean the print head.
Replace ribbon.
Change paper type.
ENGLISH VERSION EO1-33005
12. TROUBLESHOOTING
Solution

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

B-452-ts12-qpB-452-ts12-qp-pac

Table of Contents