Table of Contents
Advertisement
User's Manual
LAN
The computer has built-in support for Ethernet LAN (10 megabits per second,
10BASE-T) and Fast Ethernet LAN (100 megabits per second, 100BASE-Tx).
This section describes how to connect/disconnect to a LAN.
CAUTIONS: 1. Do not install or remove an optional memory module
NOTES: 1. The Wake-up on LAN function consumes power even when
the system is off. Leave the universal AC adaptor con-
nected while using this feature.
2. When the Wake-up on LAN function is activated, the LAN
indicators do not glow while the computer is in standby
mode (while it is waiting for a LAN wake-up signal).
Connecting LAN cable
CAUTION: The computer must be configured properly before connecting
to a LAN. Logging onto a LAN using the computer's default settings
could cause a malfunction in LAN operation. Check with your LAN
administrator regarding set-up procedures.
If you are using Fast Ethernet LAN (100 megabits per second, 100BASE-TX), be
sure to connect with a CAT5 cable. You cannot use a CAT3 cable.
If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you can
connect with either a CAT5 or a CAT3.
To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices connected to
the computer.
4-26
while Wake-up on LAN is enabled.
2. Do not connect any cable other than a LAN cable to
the LAN jack. It could cause damage or malfunction.
3. Do not connect the LAN cable to a power supply. It
could cause damage or malfunction.
Advertisement
Table of Contents
