Toshiba e740 User Manual page 171

Symptom
Following message is
displayed:
"Not Enough Battery
Power. There is not
enough battery power
to use USB Device"
Following message is
displayed:
"USB OVER CURRENT
DETECT USB device is
turned off. Please
disconnect USB
device."
Symptom
Cannot connect to the
network
The host computer cannot
wirelessly connect with my
Pocket PC?
User's Manual
Cause
The Battery power is too
low to use USB devices.
The total power
consumption of
connected USB devices is
too large.
The total power
consumption of
connected USB devices is
too large.
Solutions
■
Make sure the Wireless Communication Switch is
turned on.
■
Check if the SSID is correct (note that it is case-
sensitive)
■
Check Link Quality in Configuration Page. If the link
quality is poor, rescan and find another Access Point.
■
Check if the operating mode is set properly. See
Chapter 4, Configuration Page.
■
Check if the WEP key is correctly entered.
■
Be sure you are in the range of a working Access
Point.
■
Make sure the channel been set is in the range of
1~11.
■
Make sure you have setup the partnership for your
Pocket PC and your host computer.
■
Make sure you are within the range of a working
network.
■
Make sure you have entered the IP address of the
host computer as the WINS server on your Pocket
PC.
■
Reset your Handheld PC or Pocket PC to make the
TCP/IP settings take effect.
■
Make sure the SSID, WEP keys and channel for all
devices in the network are set the same.
■
Make sure the channel been set is in the range of
1~11.
Additional Information
Correction
Charge the battery or connect
AC adapter.
This USB port supports total
500mA USB device. Confirm
connected USB device.
This USB port supports total
500mA USB device. Confirm
connected USB device.
To enable USB port again, turn
off the power of Pocket PC and
push Reset Switch.
12-3