Programming Worksheet - UTC Fire and Security Interlogix NX-8E Installation Manual

Appendix B: Reporting codes

Programming worksheet

Use the following worksheet to check location defaults and record location
settings. Locations with multiple segments will show defaults as multiple numbers
separated by commas. Defaults are shown in bold.
Table 19: Location defaults and settings
Loc. Description
0 Phone 1 (20 segments)
1 Phone 1 account code
2 Phone 1 communicator format
3 Phone 1 dial attempts
Backup control
4 Phone 1 events reported
Segment 1
1 = Alarm s and restores
2 = Open/close
3 = Bypass
4 = Zone trouble
5 = Pow er trouble
6 = Siren and telephone fault
7 = Test reports
8 = Program, download and log full
5 Partitions reported to phone 1
Segment 1 = Partitions 1 to 8
6 Phone 2 (20 segments)
7 Phone 2 account code
8 Phone 2 communicator format
9 Phone 2 dial attempts
Backup control
10 Phone 2 events reported
Segment 1
1 = Alarms and restores
2 = Open/close
3 = Bypass
4 = Zone trouble
5 = Pow er trouble
6 = Siren and telephone fault
7 = Test reports
8 = Program, dow nload and log full
11 Partition reported to phone 2
Segment 1 = Partitions 1 to 8
12 Phone 3 (20 segments)
76
Default
14 (each segment)
10, 10, 10, 10, 10, 10
0
8
0
Segment 2
1 - Tam pers
2 = Short circuit and ground fault
3 = Sensor lost
4 = Sensor low battery
5 = Expander trouble
6 = Failure to com municate
7 = Zone activity m onitor
8 = Reserved
1 2 3 4
14 (each segment)
10, 10, 10, 10, 10, 10
0
8
0
Segment 2
1 - Tampers
2 = Short circuit and ground fault
3 = Sensor lost
4 = Sensor low battery
5 = Expander trouble
6 = Failure to communicate
7 = Zone activity monitor
8 = Reserved
1 2 3 4
14 (each segment)
NX-8E Control Panel Installation Manual
Setting
5 6 7 8
5 6 7 8