Glossary - UTC Fire and Security Interlogix NX-8E Installation Manual

Glossary

Abort
AC fail/lower battery
report/warning
AC power/low battery sounder
alert
Arm/disarm codes
Automatic arming
Automatic bypass/instant
arming
NX-8E Control Panel Installation Manual
In enabled, the NX-8E waits the number of seconds
programmed in Location 40 prior to sending an alarm. During
this delay time, the Cancel LED flashes. To abort the report,
type in a code and press the Cancel key. The LED extinguishes.
If the report is not aborted within the allotted time, the LED
extinguishes when the report is sent (a dialer delay must be
enabled). (Locations 40 and 110 to 169)
If programmed, the NX-8E reports AC failure and/or low battery
conditions to the central station. It also sounds the keypad
immediately upon detection of the condition. If programmed, the
NX-8E delays the AC failure report/warning. (Locations 37 and
39)
If enabled, the NX-8E beeps the keypad sounder upon arming
or disarming if the AC power is missing or a low battery is
detected. (Location 23)
The NX-8E has eight four-digit or six-digit codes to arm/disarm
the control panel. All codes must have the same number of
digits. The default for user 1 is 1234 when using a four-digit
code, or 123456 for a six-digit code. Use this code to enter the
new arm/disarm codes. (Location 41)
If programmed, the NX-8E auto arms at a specified time. At this
time, the keypad beeps for 50 seconds before the panel arms.
When a code is entered on the keypad, the arming process
stops. The NX-8E attempts to arm after every 45 minutes of
inactivity until the next opening time or until the system is
armed. The 45-minute timer is extended when there is activity in
the building that causes the Ready LED to turn off and on. The
user code is 97 if closing reports are sent. (Locations 23, 52 to
55)
When enabled, the control panel automatically bypasses interior
follower zones if an exit is not detected during the exit delay
time. Entry delay zones are made instant. (Location 23)
101