Chapter 2: Reporting codes
Programming locations
This section describes all the programming options for the control panel.
Quick start programming
For most routine installations, the quick start locations allow you to enable a
majority of the options available with the NX-8E (when communicating in Contact
ID or SIA formats). The quick start locations include:
•
Location 0 - Phone 1
•
Location 1 - Phone 1 account code
•
Location 2 - Phone 1 communicator format
•
Location 3 - Phone 1 dial attempts/backup control
•
Location 6 - Phone 2
•
Location 7 - Phone 2 account code
•
Location 8 - Phone 2 communicator format
•
Location 19 - Download access code
•
Location 20 - Number of rings to answer
•
Location 21 - Download control
•
Location 22 - Download call back number
•
Location 23 - Feature report selection/partition feature selection
•
Location 24 - Entry/exit times
•
Location 25 - Zone type selection for zones 1 to 8
•
Location 37 - System reporting, operation, and siren options
•
Location 38 - Swinger shutdown count
•
Location 39 - Keypad sounder control
•
Location 40 - System timers
•
Location 42 - Go to program code
•
Location 44 - Duress code
•
Location 51 - Autotest control
Locations 0 to 18 - Reporting
Location 0 - Phone 1
Location 0 has 20 segments of numerical data. Use this location to program
phone 1. The default for each segment is 14.
•
To program a delay of 4 seconds, enter 13 in the appropriate segment.
•
To program tone dialing, enter 15 in the segment where tone dialing begins.
•
If the entire number is tone dialing, enter 15 in the first segment.
•
Enter 11 for a *, and 12 for a #.
18
NX-8E Control Panel Installation Manual