Bracket Installation - I-Semble REVISED VERTICAL MURPHY BED Instructions Manual

Left
Cabinet
Front
Side
Edge
1
6 ⁄
15
16
17 ⁄ "
11
16
13 ⁄ "
7
8
3 ⁄ "
1
8
11 ⁄ "
7
16
Drilling Guide

Bracket Installation

1. Cut all pieces to the dimensions listed for your
bed size.
2. Mark the drilling locations on the right and left
cabinet Sides (1) for the Threaded Inserts (T) that
will be used to attach the Mounting Plates (I).
Drilling Guide.
I
1
T
Fig. 1
8
2 ⁄ "
1
2
2 ⁄ "
1
2
7 ⁄ "
9
16
"
6 ⁄ "
1
4
I
9 ⁄ " 11 ⁄ "
7
7
16
16
U
27/64" diameter x
9/16" deep pilot hole
2 ⁄ "
1
2
2 ⁄ "
1
2
7 ⁄ "
9
16
6 ⁄ "
1
4
11 ⁄ "
7
16
3. Drill a 27/64"diameter x 9/16" deep pilot hole at
each location. Fig. 1.
Do NOT use other fasteners, such
as standard wood screws, to attach the Mounting
Plates (I) to the Sides (1). The forces involved in the
operation of the bed mechanism could cause less
robust fasteners to fail, potentially resulting in serious
personal injury.
4. Use an 8mm Allen Key (not included) to drive the
Threaded Inserts (T) into the pilot holes. Drive the
inserts flush to the surface of the Sides, but take care
not to strip the hole by driving too far. Fig. 1.
5. Using the #5 Allen Key (S2), attach the Mounting
Plates (I) to the Sides (1) with M8 x 16mm Screws (U)
threaded into the Threaded Inserts (T). Wait until you
have installed all screws to fully tighten. Fig. 1.
Right
Cabinet
Front
Side
Edge
1
6 ⁄ "
15
16
17
11
13 ⁄ "
7
8
I
3 ⁄ "
1
8
11 ⁄ "
7
16
9 ⁄ "
7
16
⁄ "
16