Final Touches - I-Semble REVISED VERTICAL MURPHY BED Instructions Manual

5
Fig. 17
V
Fig. 18
18
4. Hook the Door Panel(s) (5) onto the frame and
push down until they are firmly in place. Center and
fine-tune the position of the Door Panel(s). Fig. 17.
weight of a mattress. You MUST have an adult helper
hold down the bed to avoid the risk of serious injury
from the bed suddenly slamming shut.
5. Pull the bed frame down and have an adult helper
hold it down.
Panels to the frame, make sure their outside edges
won't contact the Mounting Plates or any of their
hardware. Door Panels MUST NOT hit the hardware
when the bed legs are retracted and the bed is
lowered beyond the normal horizontal position. If they
do, then you MUST either fine-tune the position of the
Door Panels on the frame, or the Door Panels' width
MUST be reduced.
6. Permanently attach the frame to the Door Panel(s) (5)
by driving #8 x 15mm Screws (W) through the
mounting tabs on the frame into the Door Panel(s).
You will drive 20 screws for a Twin bed and 28 screws
for a Full or Queen bed. Fig. 18.
7. Reinforce the connection by driving #10 x 55mm
Screws (V) through mounting holes in the full
frame at 26 locations around the frame. Fig. 18.
Do NOT drive screws through the Long Center
Frame Support (D).

Final Touches

W
> The bed will not stay down without the weight of a
mattress. You MUST have an adult helper hold
down the bed to avoid the risk of serious
injury from the bed suddenly slamming shut.
1. Install the remaining Slats (O), Slat Caps (P) and
Double Slat Caps (Q). These will go in Rows 8 and
20 in Twin and Full beds and Rows 8, 11 and 20 in
Queen beds. Use a rubber mallet to tap the Slat Caps
and Double Slat Cap into place, if necessary. Fig. 19.
2. Install the Mattress Support(s) (H) at the head of the
frame by inserting the ends into the appropriate holes
in the frame. Twin beds will have one Mattress
Support; Full and Queen beds will have two.
Fig. 20.
The bed will not stay down without the
Before permanently attaching the Door