Install The Frame In The Cabinet - I-Semble REVISED VERTICAL MURPHY BED Instructions Manual

Install the Frame in the Cabinet

> To avoid the risk of serious injury, Do NOT unscrew
the bed cabinet from the wall once the pistons are
in place.
1. Attach the Pistons (G1) to the bed frame on each side
by fitting the opening on the end with the internal rod
onto the threaded stud beyond the pivot point at the
head of the frame. Secure the Pistons to the frame with
M8 Lock Nuts (FF). Fig. 10.
2. Install the frame in the Mounting Plates (I) by
positioning the bearing of the pivot point on the
Left/Right Sides of the Frame (A) in the saddle
of each plate.
3. Secure the bearing on each side in place with a Saddle
Locking Plate (J). The tab at the front of the plate fits
into an opening in the saddle, and the plate is secured
to the saddle with an M5 x 15mm Screw (Z) and M5
Nut (EE). Fig. 11. Tighten the Screw fully.
The application of a thread-locking
liquid to the M5 x 15mm Screw (Z) is recommended to
ensure the M5 Nut (EE) remains securely tightened.
Once the pistons are attached to the
Mounting Plates, the unit is under pressure. Do NOT
let go of the mechanism if you have pulled the bed
frame down; the bed frame could snap up suddenly,
possibly causing serious injury.
4. Carefully tilt the frame upward past the front edge of
the cabinet and hold it there. Fig. 12. On each side,
fit the end of the Piston (G1) onto the threaded stud
on the Mounting Plate (I) and secure with an M8
Lock Nut (FF). Fig. 13.
Frame
pushed
past the
edge of
the cabinet
Fig. 12
Bed Frame
G1
FF
Fig. 10
Mounting
Plate Saddle
Pivot Point
Fig. 11
Fig. 13
Pivot Point
I
Z
J
EE
FF
G1
15