Attach The Door Panels - I-Semble REVISED VERTICAL MURPHY BED Instructions Manual

Measurements
are for the
placement of
this hole
Fig. 16

Attach the Door Panels

> Do NOT use an impact driver to drive fasteners;
the added torque of an impact driver increases
the risk of stripping the pilot holes and weakening
connections. Do NOT overtighten screws.
1. Refer to Fig. 16 to determine Door Bracket (L)
mounting number and locations for your bed size.
Note that the brackets need to point downward when
6"
5
Back of
Door Panel
L
Twin and Full Bed Door Panel
(2 Panels required for Full Bed)
6"
6"
10"
27 ⁄ "
5
16
27 ⁄ "
5
16
Queen Bed Door Panel
(2 Panels required for Queen Bed)
installed and that the locations shown are for the
bottom mounting hole on the Door Brackets.
2. Drill 5/64" diameter x 5/8" deep pilot holes at those
locations on your Door Panel(s) (5) and attach each
Door Bracket (L) with two #8 x 15mm Screws (W).
3. Mount your door handle(s)(not included) to the front
face of your Door Panel(s)(5) at a height that will
allow you to comfortably pull down the bed. About
one-third of the way down from the top of the door
is a good rule of thumb.
6"
5
30 ⁄ "
3
Back of 4
Door Panel
30 ⁄ "
3
4
10"
17