Installation
14
Looking inside the
service door opening,
remove the retaining
screw(s) that secure the
control board. Lift the
control board high
enough that you can see
the H7 connector a the
bottom of the board.
Attach the Brown & Orange wires of the WaveReader
interface harness to this connector (orange on bottom),
then re-secure the control board in the machine.
15
Attach the WaveReader to the
bracket with the four SRW-
632X.125PM screws provided.
DO NOT USE ANY OTHERS SCREWS
TO ATTACH THE READER. DOING SO
MAY DAMAGE THE READER AND
VOID THE WARRANTY!
www.heartlandmicropayments.com
11