Makita BFL060F Series Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Spiral Bevel Gear 9 Section
DISASSEMBLING
1) Remove Light cover by unscrewing two M4x8 Pan head screws, then remove Switch lever and Compression spring 2.
(Fig. 12)
2) Remove Angle head complete from Housing by unscrewing four M4x22 (+) Pan head screws, then remove Clutch
section (= Clutch assembly) from Angle head complete. (Fig. 13)
Note: Be careful not to lose Compression spring 5, which may pop out from Clutch section when Clutch section is
removed from Angle head complete. (Fig. 13)
Fig. 12
Angle head complete
3) Using 1R173, remove Retaining ring R-22 that retains Spiral bevel gear 9 section in Angle head complete. (Fig. 14)
Spiral bevel gear 9 section can now be removed by tapping the end surface of Angle head complete with plastic hammer.
(Fig. 15)
Fig. 14
4) Remove Retaining ring S-10 using 1R291, then remove Ball bearing 6900LLB using 1R269.
Spacer and Needle bearing 1210 can now be removed from Spiral bevel gear 9. (Fig. 16)
Fig. 16
Retaining ring S-10
Housing
Switch lever
Compression spring 2
Light cover
1R173
Retaining ring R-22
Ball bearing 6900LLB
1R291
Fig. 13
(+) Pan head screws M4x22 (4 pcs)
Fig. 15
1R269
P 6 /15
Clutch section
(= Clutch assembly)
Compression spring 5
Spiral bevel gear 9 section
Spacer
Needle baring 1210
Spiral bevel gear 9