Makita BFL060F Series Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. LED Job Light Section
DISASSEMBLING
1) Remove Light cover by unscrewing two M4x8 Pan head screws. (Fig. 2)
2) Remove LED circuit and its Lead wires from Light holder, and disconnect Connector of LED circuit with that of
Controller. Switch lever and Compression spring 2 can be removed in this step. (Fig. 3)
Fig. 2
Pan head screw M4x8
ASSEMBLING
1) Connect Connector of LED circuit with that of Controller. and put LED circuit in place on Light holder.
Then fix Lead wires with tabs of light holder as illustrated in Fig. 4.
2) Fitting the protruding portion of Light cover in the notch of Angle head complete, assemble Light cover to
Angle head complete by screwing two M4x8 Pan head screws. (Fig. 5)
Note: Be careful not to pinch the slack portion of Lead wires between Light cover and Angle head complete.
Fig. 4
tab
Put Connectors and the slack portion of Lead wires
in this space.
Note: Be careful not to put them on LED circuit
nor the ribs around LED circuit.
Fig. 3
Light cover
LED circuit
Connector of LED circuit
Light holder
Connector of Controller
Fig. 5
protruding portion
Light cover
Compression spring 2
Switch lever
Controller's lead wire
notch of
Angle head complete
P 4 /15