Makita BFL060F Series Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Spindle Complete Section
DISASSEMBLING
1) Remove Bearing retainer 14-23 from Angle head complete by turning clockwise with 24mm wrench. (Fig. 6)
Spindle complete section can now be removed by pulling by hand. (Fig. 7)
Fig. 6
24mm
2) Remove Flat washer 6 from Spindle complete. (Flat washer 6 may remain in Angle head complete.)
Remove Spindle complete from Bearing retainer 14-23 by pushing down Bearing retainer 14-23 in the direction of
the arrow by hand. (Fig. 8)
Note: If cannot be removed by hand, disassemble by pressing down Spindle complete using arbor press. (Fig. 9)
Fig. 8
Flat washer 6
Spindle complete
Bearing retainer 14-23
ASSEMBLING
1) Apply Makita grease N.No.2 to O ring 14. (Fig. 1 on page 3)
Assemble O ring 14, Flat washer 14 then Spindle complete to
Bearing retainer 14-23 as illustrated to left in Fig. 10.
Note: If you cannot assemble Spindle complete to Bearing
retainer 14-23 by hand, do it using arbor press
as illustrated to right in Fig. 10.
2) Apply about 2g of Makita grease N.No.2 to the Gear room of
Angle head complete. (Fig. 1 on page 3)
Note: Be careful not to put Makita grease N.No.2 on the threaded
portion of Angle head complete.
3) Apply Loctite 603 to the threaded portion of Bearing retainer 14-23.
(Fig. 1 on page 3)
Then assemble Flat washer 6 to Spindle complete. (Refer to Fig. 8.)
Assembling of Spindle complete section has been completed.
4) Clamp the flats of Angle head complete securely in a vise to which
1 set of 1R041 is attached, then assemble Spindle complete section
to Angle head complete by turning Bearing retainer 14-23 counter-
clockwise using 1R219, 1R220, 1R222 and A-43343 as illustrated
in Fig. 11.
Caution: When clamping Angle head complete, be very careful
not to deform it by overtightening.
Bearing retainer 14-23
Fig. 9
Fig. 7
Spindle complete section
Spindle complete
Bearing retainer 14-23
Fig. 10
Spindle complete
Flat washer 14
O ring 14
Bearing retainer 14-23
Fig. 11
Recommended tightening torque: 30 to 50N.m
1R222
A-43343
1R041
P 5 /15
1R220 1R219