Related Manuals for LAZBOY 50850-SSL
Summary of Contents for LAZBOY 50850-SSL
- Page 1 Designed to be comfortable, and built to stay that way. Mesh Chair Assembly Instructions Model 50850-SSL / 50850-SBC 275 lbs...
- Page 2 WARNINGS 1. This product should be used by only one person at a time. 2. Do not use this chair unless all bolts, screws and knobs are securely tightened. 3. Save the hexagonal wrench. Check that all bolts, screws and knobs are tight every three months or as needed. 4.
- Page 3 PARTS Casters Star Base Gas Lift Seat Plate Quantity: 5 Quantity:1 Quantity: 1 Quantity: 1 Left Arm Right Arm Seat Cushion Back Cushion Quantity:1 Quantity:1 Quantity:1 Quantity: 1 40mm Small Screws with 35mm Small Screws with 25mm Big Screws with Spring Washers Flat Washers Flat Washers and Flat Washer...
- Page 4 Step 1 Place the star base (B) upside down and insert 5 casters (A) into the holes on the star base (B). Step 2 Turn the star base (B) over and insert the gas lift (C) through the center hole on top of star base (B).
- Page 5 Step 3 Tighten the brackets of arms (E1 & E2) onto the bottom of the seat cushion (F) (with front of arms facing the front of seat cushion) by using 40mm small screws with at washers (H). Note: Tighten the screws completely. Step 4 Attach seat plate (D) to the bottom of the seat cushion (F) (with the front of the seat plate facing the front of seat...
- Page 6 Step 5 Insert back cushion (G) into the rear hole of the seat plate (D) as shown. Then secure with 25mm big screws with spring washers and at washers (J). Note: Tighten the screws completely. Step 6 Position the assembled chair upright with the seat plate facing down.
-
Page 7: Function Instruction
Operating Instructions Function Instruction - 1 To Adjust Seat Height: While seated, lean forward and reach under the right side of the chair to nd the handle. Lift the handle and raise your body up slightly to allow the chair to rise to the desired height. Once desired height is reached, release handle to lock chair at desired height. - Page 8 Function Instruction - 3 To Adjust Seat Depth: Reach under the left side of the chair to nd the handle. Lift the handle and adjust the seat depth short enough to enable your legs to move freely under the chair. To adjust seat depth, lift the handle and slide the seat into the preferred position.
- Page 9 Function Instruction - 5 To Adjust Armrests Forward and Backward: While seated, grasp the armrests and push them forward or backward to a desired position. Function Instruction - 6 To Adjust Armrests Angle: While seated, grasp front end of armrests and pivot them to the left or right.
- Page 10 Function Instruction - 7 To Adjust Lumber Support Height: Lumber support height adjust independently for the short and tall. Function Instruction - 8 360˚ Swivel: 360˚ seat swivel.