Crosswater Belgravia US-BL002 Installation Instructions

Belgravia Floor-standing Pillar Legs
US-BL002
Installation Instructions
Introduction
The floor-standing legs have been fully inspected throughout the
production process and only leaves our factory after a 15-step QC
process.
Carefully remove the floor-standing legs from the box and check that
all parts have been supplied.
Before beginning installation, please check for any damage that may
have occurred during transport. Note: Damage claims cannot be
made during or after installation.
Improper installation shall result in loss of warranty in case of damage
caused by impacts or rubbing against rough surfaces.
Prior to installing the floor-standing legs prepare a connection of water
inlet/outlet.
The customer may choose the type and location of the faucet,
installation instructions should be supplied by the faucet manufacturer.
IMPORTANT: Please read these instructions carefully before
beginning and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.
Installation notes
The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
Anti-scald protection is the responsibility of the installer and
according to applicable codes.
Install US-AA002ROUGH first using the instructions provided with
it.
IMPORTANT! Before installing a new faucet it is essential that the
supply pipes are thoroughly flushed in order to remove any remaining
debris, solder or other impurities. Failure to carry out this simple
procedure can cause problems or damage to the working of the
faucet. Installing shut-off valves on incoming supply lines is
recommended for ease of maintenance.
Turn off the main water supply before connecting to any existing
pipework or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise, before drilling holes in a wall or floor.

Tools required

Tape
measure
Safety Set
glasses square
Dimensions
1 / " NPSM
2
Pencil Spirit
level
3-1/8"
7"
Silicone
sealant