Set Up Procedure; Fingerprint Registration - Toshiba Qosmio G40 User Manual

Set Up Procedure

Please use the following procedure when first using fingerprint
authentication.

Fingerprint Registration

You should initially enroll the required authentication data using the User
Enrollment Wizard.
■
In use, the fingerprint authentication system will use the same
username and password as defined within the Windows operating
system. If no Windows password has been configured, you must do
this before starting the fingerprint registration process.
■
Up to twenty-one fingerprint patterns can be registered on this sensor.
1. To run this program, click Start -> All Programs -> Protector Suite QL
-> User Enrollment.
You are also able to start the User Enrollment Wizard by using the
following methods.
■
Click the Protector Suite QL icon in the Task Bar.
■
Swipe your finger across the Fingerprint Sensor.
2. Click Next.
3. At the User's Password screen which is then displayed, you should
ensure that the same Windows username is displayed before entering
the appropriate password into the Enter your password field. Once
this has been done, click Next.
4. At the Hints for Fingerprint Enrollment screen, confirm the message
displayed and ensure that there is a check mark in the Run Interactive
Tutorial box. Once this has been done, click Next.
5. At the Correct Swipe Procedure screen, confirm the message that is
displayed and then click Next.
6. At the Scanning Practice screen, you are able to practice swiping your
finger to ensure you use the correct method. Once you have finished
practicing, click Next.
7. At the User's Fingers screen, select the finger that you wish to enroll
from the illustration and then click Next. On this screen please be
aware that any previously enrolled fingerprints would have green check
marks, while the fingerprint that you are about to enroll will have a red
check mark. If any of the previously enrolled fingerprints is selected
again, the latest information will be enrolled and any previous
information over-written.
8. At Advanced Security screen, select whether you wish to enable the
security function, and then click Next.
9. At Finalization screen, click Finish - this will complete the fingerprint
registration process.
User's Manual
Operating Basics
4-7