Advertisement
Installation Instructions
Hand Push Models Only:
A. Loosen the jam nut on the brake cable (Fig. 15).
1
4
6
Figure 15
Hand Push Model
1. Handle
2. Brake lever
3. 3/16"-1/4"
B. Insert a 3/16 in. to 1/4 in. object between the brake
lever and the handle (Fig. 15).
C. Turn the cable adjuster on the brake cable until
there is no slack.
D. Tighten the nut.
Self-propelled Models Only:
A. Insert the blade brake cable into the cable support.
B. Assemble the cable support to the right side of the
handle. Do not tighten the locknut.
C. Hook the blade brake cable to the control bar lever.
D. Insert a 3/16 in. to 1/4 in. object between the brake
lever and the handle (Fig. 16).
2
Figure 16
Self-propelled Model
1. Handle
2. Brake lever
8
2
3
5
483
4. Cable adjuster
5. Jam nut
6. Cable conduit
1
3
4
3. 3/16 in. to 1/4 in.
4. Cable bracket
E. Pull down on the cable conduit until there is no
slack in the wire.
F. Tighten the nut.
G. Secure the blade brake cable to the right side of the
handle with two cable ties.
Installing the Starter Rope in Rope Guide
Install the starter rope in the rope guide (Fig. 1).
Installing the New Cable Ties
Attach the cables to the lower left side of the handle using
the new cable ties.
Self-propelled Models Only: Replace the old decal on
the control bar with the new decal (Fig. 17).
Figure 17
1. Decal
Installing the New Engine Decal
Install the new decal on the engine as illustrated in
Fig. 18.
1
Figure 18
1. Decal location
Before Starting the Engine
For information on how to fill the crankcase with oil,
fill the fuel tank with gasoline, and operate the engine,
refer to your Kawasaki Engine Owner's Manual.
1
Advertisement
