Advertisement
Installation Instructions
DESCRIPTION
Square Key 3/16 x 1.25 (HP Models) or
3/16 x 0.50 (SP Models)
Oil Drain Tube
Brake Cable
Blade Retainer
Blade Spacer
Drive Pulley (SP Models only)
Before Installing
POTENTIAL HAZARD
If you leave the wire on the spark plug,
someone could accidentally start the engine.
WHAT CAN HAPPEN
Someone accidentally starting the engine can
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Disconnect the wire from the spark plug before
you install the kit. Set the wire aside so that it
does not accidentally contact the spark plug.
1. Disconnect the wire from the spark plug.
POTENTIAL HAZARD
If gasoline is spilled on a hot engine, it could
ignite.
WHAT CAN HAPPEN
Contact with burning gasoline could cause
serious personal injury.
HOW TO AVOID THE HAZARD
Drain the gasoline from a cold engine only.
2. Make sure that the engine is cool. Remove the cap
from the fuel tank and use a pump-type syphon to
drain the fuel into a clean, approved gasoline
container.
Note: This is the only procedure that Toro recommends
for draining the fuel.
2
QTY.
1
Installing the blade assembly
1
Draining the engine oil
1
Replacing the brake cable
1
Replacing the blade retainer and the drive
1
pulley
1
3. Connect the wire to the spark plug.
4. Start the engine and let it run until it runs out of fuel.
5. Disconnect the wire from the spark plug.
6. Drain the engine oil (Refer to your operator's manual
for the procedure).
Disassembly
Removing the Starter Rope
Remove the starter rope from the rope guide (Fig. 1).
1. Rope guide
Removing the Cable Ties
Cut the cable ties that hold the cables to the handle.
Removing the Fuel Tank
1. Disconnect the fuel line from the engine (Fig. 2).
USE
1
2
m–2705
Figure 1
2. Starter rope
Advertisement
