Page 1
Never operate mower without hardware mounted in all holes in mower. Install hardware in mounting holes when mulching baffle is removed. 2002 by The Toro Company 8111 Lyndale Avenue South All Rights Reserved Bloomington, MN 55420-1196 Printed in the USA...
Page 2
Installing the Baffle Important Make sure the bolt heads are installed on the inside of the cutting chamber. 1. Place the baffle inside the front of the cutting chamber (Fig. 2). 2. Position the baffle so the outside ends are tight against the cutting chamber and there is equal distance between the baffle radius’...
Page 3
Installing the Kickers Important Make sure the bolt heads are installed on the inside of the cutting chamber. 1. Measure from the spindle center lines, and locate kickers as shown in Figure 3. 2. Holding kickers tight against the cutting chamber, mark and drill a hole for each kicker (11/32 inch dia.) (Fig.
Page 4
Installing the Recycler Blades Removing Baffles for Side Discharge Cutting 1. Hold the blade end using a rag or thickly-padded glove. Remove the blade bolt, blade stiffener and blade from Note: Keep the rear 3 kickers attached to the mower. the spindle shaft (Fig.