Installing A Memory Module - Toshiba NB500 Series User Manual

Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.

Installing a memory module

To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the screws securing the memory module cover in place - please
note that the screws are attached to the cover in order to prevent them
from being lost.
Use a point size 0 Phillips screwdriver.
6. Slide your fingernail or a thin object under the cover and lift it off.
1. Screws
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 30 degree angle before
holding it down until the latches on either side snap into place.
User's Manual
NB500/NB505/NB520/NB525/NB550D/NB555D Series
Turning off the power
Figure 3-7 Removing the memory module cover
section in Chapter 1, Getting Started if
section in Chapter 5, Power and Power-Up
2. Memory module cover
3-19